Setting up blueprints in c4d

6 Responses to Setting up blueprints in c4d

1. SubscribeToKiyo655 says:

   February 5, 2012 at 1:59 am

   how can you give it better quality?
2. SubscribeToKiyo655 says:

   February 5, 2012 at 2:22 am

   @bruhe yh but the thing is tht most of us get an error that doesnt let us do anything then c4d crahses so i think this is a pretty good way to do it
3. you2ube5000 says:

   February 5, 2012 at 2:24 am

   thanhs very very much
4. bruhe says:

   February 5, 2012 at 3:10 am

   Most would suggest you use the 4 view port setting and in the appropriate viewport, click Edit and then on the Back tab, put your picture there. But however you get your results to be best is the way you should do it
5. flarefilmproductions says:

   February 5, 2012 at 3:44 am

   how would you go about modeling a yacht from blueprints? There are usually no front and rear prints.
6. zootier says:

   February 5, 2012 at 4:04 am

   How do I know how big my surface must be so the blue print is not distorted projected on it?